A parallel transfer is used when you need to end one chain pull and begin another. This transfer insures a smooth product transition by moving the product from one chain to the other by sliding it over, without the use of a deadplate. A parallel transfer may be used when the size of the product will not allow for an end to end transfer or to break up line back pressure for better line control. If product spacing is a concern, a parallel transfer may be used by incorporating a speed change between the infeed and discharge chains.

Component Specifications:

-4’-0” O.A.L. with standard below motor mount (325,450, 750)
-5’-0” O.A.L. with standard below motormount (1500)
-Minimum 1/16” gap between chains
-8” deep frame