TREAD ROLLERS:
1.9" dia. x 16 ga. steel, model 196S grooved.
DRIVE BELT:
3/16" dia., polyurethane belts. Nominal 15 lbs. per roller drive.
DRIVE SHAFT:
1" dia. C1018 cold rolled steel shaft.
COUPLINGS:
Couplings located both ends (type "A"), one end only (type "B" or "C") or none (type "D"). See 'line shaft coupling chart' opposite page,
and specify.
CENTER DRIVE:
Located approximately 16-1/2" from end of bed section on 4" RC; 18" on 3" and 6" RC.
ACCUMULATION:
Zone singulation
operation; 2'-0" zone length; zones are pneumatically actuated using photo
electric sensors.
FRL:
Unit is provided with filter, regulator, lubricator with 1/4" ports.
|
|
SPEED:
60 FPM, constant. BEARINGS:
All bearings are precision, lubricated, ball bearing units with composite housings.
BED:
7" x 1-1/2" x 12 ga. formed steel channel frame. Bed sections attached with splice plates and floor supports.
FLOOR SUPPORTS:
SM-6 adjustable 31-1/2" to 43-1/2" TOR. Supports should be lagged to floor.
MOTOR DRIVE:
1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.
ROLLER CHAIN:
Drive shaft is driven by No. 50 chain. Chain take-up provided on motor base.
CAPACITY:
See page 5 in technical
section for load capacity rating.
ELECTRICAL CONTROLS:
Optional |
