TREAD ROLLERS: 2-1/2" dia. x 11 ga. steel, model 251S.
PRESSURE ROLLERS: 1.9" dia. x 16 ga. steel, model 196S; 27" BF for all widths.
RETURN ROLLERS: 1.9" dia. x 16 ga. steel, model 196S, adjustable.
BELTING: 24" wide PVC-120 COS.
side mount end DRIVE: Allows one direction unit operation.
DRIVE PULLEY: 12" dia., with 1-15/16" dia. shaft, crowned and fully lagged.
TAIL PULLEY: 8" dia., crowned, with
1-3/16" dia. shaft.
TAKE-UP: Screw type unit at tail pulley
provides 12" belt take-up.
BED: 5" x 1-1/2" x 3/16" formed
steel channel frame slotted for tread rollers to pop-out. When unit is installed at
7'-0" elevation or higher, rollers must be retained in conveyor. Specify desired
elevation. Bed sections are bolted together with butt couplings and floor supports.
SPEED: 35 FPM, constant.
|
|
BEARINGS: All pulley bearings are
precision, heavy duty, lubricated, ball bearing units with cast iron housings.
ACCUMULATION: 5'-0" long zones
with zone singulation operation. 1'-6" of live roller over end plates at each
end of conveyor remains "live" during operation (# of zones x zone length +
3'-0" = overall conveyor length). Zones are pneumatically actuated by using photo electric sensors.
PNEUMATIC ACTUATION: Recommended air line pressure is 60
PSI.
FLOOR SUPPORTS: SH0-2 at end plates
and SH-3 at intermediates provides 18" to 18-1/2" TOR. Supports provided on 5' centers and should be lagged to floor.
MOTOR DRIVE: 1 HP, 230/460/3, 60 cycle, ODP right angle gear motor.
ROLLER CHAIN: No. 60 chain provided at drive pulley. Chain take-up provided on motor base.
ELECTRICAL CONTROLS:
Optional
|
