TREAD ROLLERS: 1.9"
dia. x 16 ga. steel, model 196S grooved, 3" centers.
DRIVE BELT: 3/16"
dia., polyurethane belts. Nominal 15 lbs. per roller drive.
DRIVE SHAFT: 1"
dia. C1018 cold rolled steel shaft. NOTE: Spools in spur section only are keyed to provide positive drive (designed not to slip on drive shaft).
COUPLINGS: Couplings located both ends or one end only. Specify where couplings required.
BED: 7" x 1-1/2" x 12
ga. formed steel channel frame. Short side of spur is always 12" overall length.
|
|
BEARINGS: Precision, lubricated, ball bearing units with composite housings.
FLOOR SUPPORTS: SM-6 adjustable
31-1/2" to 43-1/2" TOR. Supports should be lagged to floor.
MOTOR DRIVE: Unit is designed to be
driven by 796LS.
ROLLER CHAIN: Spur driven via crossover with No. 40 chain. |
