TREAD ROLLERS: 1-3/8" dia. x 18 ga.
galvanized steel, model 138G w/ 5/16"
hex, grooved.
DRIVE BELT: 1/8" dia., polyurethane belts. Nominal 10 lbs. per roller drive.
DRIVE SHAFT: 1" dia. C1018 cold rolled steel shaft.
COUPLINGS: Couplings located both ends (type "A"), one end only (type "B" or "C")
or none (type "D"). See 'line shaft coupling chart'
and specify.
CENTER DRIVE: Reversible drive;
located approximately 18" from end of bed section for 3" and 6" RC;
16-1/2" for 4" RC.
BED: 7" x 1-1/2" x 12 ga. formed steel channel frame. Bed sections attached w/ splice plates and floor supports.
|
|
SPEED: 60 FPM, constant.
FLOOR SUPPORTS: SM-6 adjustable
31-1/2" to 43-1/2" TOR. Supports should be lagged to floor.
BEARINGS: Precision, lubricated, ball
bearing units with composite housings.
MOTOR DRIVE: 1/3 HP, 230/460/3, 60
cycle, ODP right angle gear motor.
ROLLER CHAIN: Drive shaft is driven by
No. 50 chain. Chain take-up provided on motor base.
CAPACITY:
See
technical section for load capacity rating.
ELECTRICAL CONTROLS: Optional. |
