|BELT: Series 2200 flush grid gray curved polypropylene belt, FDA & USDA approved belting.
DRIVE SPROCKETS: 5.3" pitch
dia. with 1.5" square bore. Available with OPTIONAL 6.3" or 7.7" pitch dia. sprockets with 1.5" or 2.5" square bore.
TAIL SPROCKETS: 5.3" pitch dia. with 1.5" square bore. Available with OPTIONAL 6.3" or 7.7" pitch dia. sprockets with 1.5"
or 2.5" square bore.
END DRIVE: Allows one-direction
operation ONLY; this conveyor is NOT reversible.
TAKE-UP: Catenary type located at
BED: 7" x 1-1/2" x 10 ga. formed steel channel frame with UHWW wearstrips attached to bed and belt return pan.
MINIMUM RADIUS: 2.2 x belt width,
measured from inside edge of belt.
||SPEED: 60 FPM, constant.
TANGENTS: Minimum length is 1.5 x belt width located at each end of conveyor;
minimum of 3' at discharge end required with 5' recommended. Optional additional tangent may be located at dischg.
FLOOR SUPPORTS: SM-6 supports
provided at both ends and at center of curve and should be lagged to floor.
BEARINGS: End shafts are supported
by precision, heavy duty, lubricated, ball bearing units with cast iron housings.
OF FLOW: Specify right hand or left hand.
MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor on 45° and 90° curves; 3/4 HP supplied on all 180° curves.
ROLLER CHAIN: Drive shaft is driven by
No. 50 chain.
ELECTRICAL CONTROLS: Optional.