|TREAD ROLLERS: Heavy duty 11 ga. tapered rollers, model 351T with
sprockets, for true taper effect.
CHAIN DRIVE: Roller to roller with
No. 60 circular roller chain.
END DRIVE: Reversible drive either side mounted or underside (specify). Main drive roller is supported by precision, heavy duty, lubricated, ball bearing units.
ROLLER CENTERS: 6" RC measured at outside radius of curve.
SPEED: 35 FPM, constant.
BED: 5" at 6.7 lbs. and 7" at 9.8 lbs.
structural steel channel frame.
BEARINGS: Removable type, heavy
duty, ball bearings, zinc plated, grease packed, labyrinth sealed.
||CHAIN GUARD: The chain drive is
enclosed, top and bottom, along the entire length of the conveyor.
FLOOR SUPPORTS: SH-4 with
underneath mounted drive adjustable 19" to 22" TOR. SH-1 with side mounted drive adjustable 11-1/2" to 13" TOR. Supports should be lagged to floor.
MOTOR DRIVE: 3/4 HP, 230/460/3, 60 cycle, ODP right angle gear motor.
DRIVE LOCATION: Drive located on
outside of curve. Specify right hand drive or left hand drive (drive hand
determined with reference point located at outside of curve).
ELECTRICAL CONTROLS: Optional.