TREAD ROLLERS: 2-9/16" dia. x 7 ga.
steel, model 297S with sprockets.*
CHAIN DRIVE: Roller to roller with No. 60 circular roller chain.
END DRIVE: Reversible drive, either side mounted or underside (specify). Main drive roller is supported by precision, heavy duty, lubricated, ball bearing units.
CHAIN GUARD: Chain drive is enclosed, top and bottom, along entire length of conveyor.
ROLLER CENTERS: 6" RC measured at
outside radius of curve.
BED: 4" at 5.4 lbs. and 6" at 8.2 lbs.
structural steel channel frame.
BEARINGS: Removable type, heavy duty, ball bearings, zinc plated, grease packed, labyrinth sealed.
|
|
MOTOR DRIVE: 3/4 HP, 230/460/3,
60 cycle, ODP right angle gear motor.
SPEED: 35 FPM, constant.
|FLOOR SUPPORTS: SH-4 with underneath mounted drive adjustable 18" to 21" TOR. SH-1 with side mounted drive adjustable
10-1/2" to 12" TOR. Supports should be lagged to floor.
DRIVE LOCATION: Drive located on outside of curve. Specify right hand drive or left hand drive (drive hand determined with
reference point located at outside of curve).
ELECTRICAL CONTROLS: Optional. |
