TREAD ROLLERS: 2-1/2" dia. x 11
ga. steel, model 251S with sprockets.
CHAIN DRIVE: Roller to roller with No. 60 circular roller chain.
END DRIVE: Reversible drive either side mounted or underside (specify). Main drive roller is supported by precision, heavy duty, lubricated, ball bearing units.
BEARINGS: Removable type, heavy duty,
ball bearings, zinc plated, grease packed, labyrinth sealed.
ROLLER CENTERS: 6" RC measured at
outside radius of curve.
MOTOR DRIVE: 3/4 HP, 230/460/3,
60 cycle, ODP right angle gear motor.
SPEED: 35 FPM, constant.
|
|
FLOOR SUPPORTS: SH-4 with underneath mounted drive adjustable 18" to 21"
TOR. SH-1 with side mounted drive adjustable
10-1/2" to 12" TOR. Supports should be lagged to floor.
BED: 6" x 1-1/2" x 7 ga. and 4" x 1-1/2" x 7 ga. formed steel channel frame.
CHAIN GUARD: The chain drive is
enclosed, top and bottom, along the entire length of the conveyor.
DRIVE LOCATION: Drive located on outside of curve. Specify right hand drive or left hand drive (drive hand determined with
reference point located at outside of curve).
ELECTRICAL CONTROLS: Optional.
|
