TREAD ROLLERS:
1.9" dia. x 16 ga. steel, model 196S.
PRESSURE ROLLERS:
1.9" dia. x 16
ga. steel, model 196S; 8" BF with 6"
wide belt.
BELTING:
6" wide black PVC-120 COS.
DRIVE PULLEY:
4" dia. with 1-3/16" dia. shaft or 8" dia. with 1-7/16" dia. shaft, both crowned and fully lagged.
END PULLEY:
4" dia., crowned, with
1-3/16" dia. shaft.
RETURN ROLLERS:
1.9" dia. x 16 ga. steel, model 196S, adjustable.
SQUARING RODS:
Adjustable rods on underside of bed allow frame to be squared for improved belt tracking and are standard on all units over 30'.
BED:
7" x 1-1/2" x 12 ga. channel frame slotted for tread rollers to pop-out. When unit is installed at 7'-0" elevation or higher, rollers must be retained in
conveyor frame. Specify desired elevation. Bed sections attached with
couplings and floor supports.
SPEED: 60 FPM, constant.
|
|
BEARINGS:
All pulley bearings are
precision, heavy duty, lubricated, ball bearing units with cast iron housings.
ACCUMULATION: 2'-0" long zones
pneumatically actuated. 1'-0" of live roller over end plates at each end of
conveyor remains "live" during operation (# of zones x zone length + 2' = overall conveyor length).
PNEUMATIC ACTUATION:
Maximum air line pressure should not exceed 30 PSI.
FRL: Unit is provided with filter,
regulator, lubricator with 1/4" ports.
FLOOR SUPPORTS:
SM-6 adjustable
31-1/2" to 43-1/2" TOR. Supports should be lagged to floor.
MOTOR DRIVE:
1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.
ROLLER CHAIN:
Drive pulley is driven by No. 50 roller chain for 1-1/2 HP or less
and No. 60 chain on larger drives. Chain take-up provided on motor base.
ELECTRICAL CONTROLS:
Optional. |
