TREAD ROLLERS: 2-1/2" dia. to
1-11/16" dia. x 14 ga. tapered rollers (model 254T); 1.9" dia. x 16 ga. (model 196S) straight tangent rollers.
PRESSURE SHEAVES: Provides drive belt pressure to upper tread rollers.
BELT: "B" section V-belt.
TAKE-UP: Screw type adjustable sheave with flat idler sheaves provided to
maintain belt tension.
TANGENTS: 12" opposite spur end on 60/30 unit; 18" opposite spur end on 45/45 unit.
BED: 7" x 1-1/2" x 12 ga. formed
steel channel frame.
BEARINGS: End shafts are supported by precision, heavy duty, lubricated, ball bearing units with cast iron housings.
FLOOR SUPPORTS: SM-6 adjustable
31-1/2"-43-1/2" TOR. Supports should
be lagged to floor. |
|
MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor, located at infeed end of curve below bed.
SPUR HAND/DRIVE LOCATION: Drive
located on outside of curve. Specify hand of spur as "left hand" or "right hand" and location of drive specified
as "left hand drive" or "right hand drive". NOTE: Drive location determined with reference point located at outside of curve. For models slave driven (less drive), specify drive shaft location.
BELT SPEED: 60 FPM, constant.
ROLLER CHAIN: Drive shaft is driven by No. 50 chain.
CAPACITY: 500 lb. total distributed
live load.
ELECTRICAL CONTROLS:
Optional |
