TREAD ROLLERS:
2-1/2" dia. to 1-11/16" dia. x 14 ga. steel tapered rollers, model 254T; 1.9" dia. x 16 ga. steel straight
tangent rollers, model 196S.
PRESSURE SHEAVES:
Provides drive belt
pressure to upper tread rollers.
BELT:
"B" section V-belt.
TAKE-UP:
Screw type adjustable sheaves provided to maintain belt tension.
TANGENTS:
1'-0" both ends on 90°;
1'-6" both ends on 45°; 1'-0" both ends on 180°. Tangent roller centers provided on 3" RC.
SPEED:
60 FPM, constant.
BED:
7" x 1-1/2" x 12 ga. formed steel channel frame.
BEARINGS:
End shafts are supported
by precision, heavy duty, lubricated, ball bearing units with cast iron housings.
FLOOR SUPPORTS:
SM-6 adjustable
31-1/2" to 43-1/2" TOR. Supports should be lagged to floor. Full support required at center of curves with 4'-0" inside radius. |
|
ROLLER CHAIN:
Drive shaft is driven
by No. 50 chain.
DRIVE LOCATION:
Drive located on
outside of curve. Specify left hand
tangent length, right hand tangent length and drive location ("left hand drive" or "right hand drive"). NOTE: Drive hand determined with reference point located at outside of curve. For models slave driven (less drive), specify drive shaft location.
CAPACITY:
500 lb. total distributed
live load.
MOTOR DRIVE:
1/3 HP, 230/460/3,
60 cycle, ODP right angle gear motor, located at infeed end of curve below bed on 45° and 90° curves; 3/4 HP supplied on all 180° curves.
SPECIAL WIDTHS:
Consult factory for pricing of ALL widths not shown.
ELECTRICAL CONTROLS:
Optional |
