TREAD ROLLERS:
1.9" dia. x 16 ga. steel, model 196S.
SENSOR ROLLERS:
1" dia. x 18 ga. galv., model 108G w/ 5/16" hex.
DRIVE WHEEL ASSEMBLY:
Drive chain powers drive wheel assembly which provides drive pressure to upper
tread rollers.
DRIVE CHAIN:
#40 roller chain. UHMW chain guides support the drive and return chain strands.
CHAIN GUARD:
Completely enclosed along the entire length of the conveyor.
END DRIVE:
Allows one-direction unit operation.
DRIVE SHAFT:
1-7/16" dia. located at discharge end of unit.
END TAKE-UP:
Manual screw type adjustment is located at infeed end.
BEARINGS: Precision heavy duty,
lubricated ball bearing units with cast
iron housings.
SPEED: 60 FPM, constant.
|
|
FLOOR SUPPORTS:
SM-6 adjustable 35" to 41-1/2" TOR. Supports should be lagged to floor.
BED:
5" x 1-1/2" x 10 ga. formed channel frame.
ACCUMULATION:
Zone singulation
operation; 3" RC = 2'-0" long zones; 4-1/2" RC = 3'-0" long zones. 1'-0" of live roller at each end of unit over end plates remains "live" during operation.
PNEUMATIC ACTUATION:
Maximum air line pressure should not exceed 10 PSI.
CAPACITY:
100 lbs. per foot distributed live load. 500 lbs. effective chain pull with spring loaded chain
tensioner.
MOTOR DRIVE:
1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.
ROLLER CHAIN:
Drive shaft is driven by No. 50 roller chain for 1-1/2 HP or less and No. 60 chain on larger drives. Chain take-up provided on motor base.
ELECTRICAL CONTROLS:
Optional. |
