TREAD ROLLERS:
1.9" dia. x 16 ga. steel rollers, model 196S.
PRESSURE ROLLERS:
1.9" dia. x 16 ga. steel, model 196S, cam adjustable.
BELTING:
6" wide black PVC-120 COS.
CENTER DRIVE:
Reversible drive with
24" integral belt take-up. For units under
8'-0" overall length, drive components must be stacked. Consult factory for
minimum unit elevation.
SQUARING RODS:
Adjustable rods on underside of bed allow frame to be squared for improved belt tracking and are standard on all units over 30'.
DRIVE PULLEY:
4" dia. with 1-3/16" dia. shaft or 8" dia. with 1-7/16" dia. shaft, both crowned and fully lagged.
END PULLEY:
4" dia., crowned, with
1-3/16" dia. shaft.
RETURN ROLLERS: 1.9"
dia. x 16 ga. steel, model 196S, adjustable. |
|
BED: 7" x 1-1/2" x 12 ga. channel frame slotted for tread rollers to pop-out. When unit is installed at 7'-0" elevation or higher, rollers must be retained in
conveyor frame. Specify desired elevation. Bed sections attached with couplings and floor supports.
BEARINGS: All pulley bearings are
precision, heavy duty, lubricated, ball bearing units with cast iron housings.
FLOOR SUPPORTS: SM-6 adjustable
31-1/2" to 43-1/2" TOR. Supports should be lagged to floor.
MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.
ROLLER CHAIN: Drive pulley is driven by No. 50 roller chain for 1-1/2 HP or less and No. 60 chain on larger drives. Chain take-up provided on motor base.
SPEED: 60 FPM, constant.
ELECTRICAL CONTROLS: Optional |
